Getting a good truss system together is hard. The carbon fibre rods have to be held rigidly, but they also have to be able to change the angle they’re sitting at. These truss blocks and ball joints do all that.
Sampling rates can make your stars good or blocky, especially if you zoom in. It all depends on a few factors like your focal length, the size of the pixels in your sensor, how good the atmospheric conditions are, and even how good your guiding is. This article shows how to get a combination of telescope and camera that will give you nice smooth stars under a range of conditions.
This is an instalment of a tutorial series on how to slave a dome. In this part we look at connecting the dome control software to the dome and mount through the ASCOM Hub. Depending on the connections you can perform the slaving calculations in the dome control software or the ASCOM Hub.
In this second part of the dome slaving series, we discuss connecting your observatory control program directly to the dome and the mount using ASCOM drivers. This is the simplest we to set it up, and allows you to use the observatory control program to do the slaving calculations.
